Do you need a permit or lift plan for a crane in Casper, WY?

Often you do not need a permit for a crane that sets up entirely on private property, but you may need one if the crane or its outriggers occupy a public street, sidewalk or alley, if the crane travels as an oversize load, or if it works near an airport. Crane operations themselves follow federal OSHA crane rules (29 CFR 1926 Subpart CC), which Wyoming enforces through its state OSHA program. Complex or critical lifts are commonly done with a written lift plan.

Casper Crane Connect is an independent referral service, not a crane company. We pass your request to local operators, who quote and perform the work themselves.

Request a Quote

Rules that cover crane work

Federal crane standard: construction crane work is covered by OSHA 29 CFR 1926 Subpart CC (Cranes and Derricks in Construction), including operator certification (1926.1427), power line safety (1926.1408) and operation rules (1926.1417).
Wyoming OSHA: Wyoming runs a state OSHA plan for most private employers. See Wyoming OSHA (Department of Workforce Services).

Permits that may apply

Street or right-of-way setups in Casper: if the crane, outriggers or traffic control occupy a city street, sidewalk or alley, contact City of Casper Engineering about obstruction or right-of-way permits before the job.
County roads: outside city limits, check with Natrona County or Converse County about work on or along county roads.
Oversize or overweight moves: moving large cranes or components on state highways can require permits from WYDOT commercial vehicle permits. Crane providers normally handle permits for their own equipment.
Near airports: cranes that would exceed certain heights near an airport, such as Casper/Natrona County International, may require notice to the FAA under 14 CFR Part 77, filed through the FAA OE/AAA portal.
Building permits: the crane usually does not need a building permit, but the project it serves may. Your contractor handles that.

When a written lift plan makes sense

Every lift is planned, and the operator handles routine picks. A written lift plan, prepared by the crane provider or an engineer, is common for critical lifts, such as loads close to the crane's rated capacity at the planned radius, two-crane (tandem) lifts, lifts over occupied buildings or roads, personnel platforms, and work near energized power lines. Your general contractor, facility owner or insurer may also require one. Ask the operator how they plan your lift.

Requirements change and vary by location, so treat this page as a starting checklist and confirm with the agency and your operator.

Ready to price your lift? Request a free crane quote and a local operator will follow up directly.

Common questions

Who gets the permit, me or the crane company?

It depends on the permit. Crane providers usually handle oversize permits for moving their equipment. Street-use or right-of-way permits are often pulled by the contractor or property owner, so agree on who is responsible when you book.

Does Wyoming have its own crane rules?

Wyoming operates a state OSHA plan. For construction cranes its rules must be at least as effective as the federal OSHA crane standard (29 CFR 1926 Subpart CC). Check with Wyoming OSHA for specifics.

How close can a crane work to power lines?

Federal rules in 29 CFR 1926.1408 set minimum clearances and planning steps for work near power lines, with greater distances for higher voltages. The operator plans around them, so mention any overhead lines in your request.

Request a crane quote

Share a few details and we will pass your request to a local crane operator who can follow up directly. Fields marked * are required.

By submitting, you agree we may share your details with local crane operators to fulfill your request. See our privacy & disclaimer.